How to remove and install stabilizers on the Razer BlackWidow V4 75%

Updated: 07-Nov-2023 | Answer ID: 13780
This answer shows you how to remove and install stabilizers on the Razer BlackWidow V4 75%.

 

Tools needed:

  • Keycap puller

  • Flathead screwdriver

  • Switch puller

  • Thin tool or pointed tweezers

You can view the video below for instructions or review a copy of the video transcript.

Ensure proper removal and installation of stabilizers to prevent damage to your keyboard.

See instructions below

How to remove stabilizers

  1. Unplug the keyboard from your PC.

  2. Remove the keycaps from the keyboard. See How to replace keycaps on a Razer keyboard for instructions.

  3. Gently pull out the switches using a switch puller. See How to remove and install mechanical switches on a keyboard for instructions.

  4. Use a thin tool to unclip the stabilizers.

    1. Push the small tabs on the stabilizers.

    2. Pull the stabilizers with your fingers.

How to install stabilizers

  1. Grab the stabilizer and put its bar underneath the keyboard’s plate.

  2. Align, then snap the stabilizer’s plastic housing back in place.

  3. Reattach your keyboard’s switches and keycaps. Firmly push them into place.

  4. Plug the keyboard into your PC and perform a test.

Is this answer helpful?