Hall Effect switches can be removed and replaced on supported Razer keyboards. Proper switch installation and calibration help ensure accurate key detection and consistent performance.
You can view the video below for instructions or review a copy of the video transcript.
Follow the steps below to safely remove, replace, and calibrate a Hall Effect switch on your Razer keyboard.
Note: To replace mechanical switches on a keyboard, see How to remove and install mechanical switches on a keyboard for instructions.
Replace keyboard Hall Effect switches
Before you start
Ensure that:
- Your Razer keyboard supports replaceable Hall Effect switches.
- The replacement switch is compatible with your Razer keyboard.
- The keyboard is disconnected from your computer and other power sources.
- You have a keycap puller and switch puller available.
Important: Do not force the keycap or switch during removal or installation. Excessive force or incorrect switch orientation can damage the keyboard or switch.
Remove the Hall Effect switch
- Power off your keyboard.
- Wired: Disconnect the Razer keyboard from your computer.
- Wireless: Turn your keyboard off.
- Use a keycap puller to gently remove the keycap from the switch you want to replace.
- Position the switch puller securely around the Hall Effect switch.
- Gently pull the switch upward until it is released from the keyboard.
Install the replacement Hall Effect switch
- Check the replacement Hall Effect switch and the switch socket for any visible damage or obstruction.
- Align the switch with the socket in the correct orientation.
- Gently press the switch straight down until it is securely seated.
Important: If the switch does not fit easily, remove it and check the orientation before trying again. Do not force the switch into the socket.
- Reinstall the keycap by aligning it with the switch stem and gently pressing it into place.
- Reconnect the keyboard to your computer.
Calibrate the Hall Effect switch
Calibrate the Hall Effect switches after replacement to ensure accurate input detection.
- Open Razer Synapse.
- Select your Razer keyboard.
- Go to the switch calibration settings.
- Follow the on-screen instructions to calibrate the Hall Effect switches.
- Test the replaced key to confirm that it registers correctly.
Troubleshoot replacement switch
If the replacement switch does not work, do the following:
- Ensure that the Hall Effect switch is compatible with your Razer keyboard and is correctly installed.
- Remove and reinstall the switch, then perform the switch calibration again in Razer Synapse.
- If the issue persists, contact Razer Support for further assistance.
